Deadpool and Wolverine Keychain

Print with 0.15 mm layer and 100% infill for best results.

With said settings, print should take about 17 minutes for Deadpool and 20 minutes for Wolverine.

You'll need to add 3 layer changes for each keychain.

DEADPOOL

• start with red filament
• at layer 16, change to white filament
• at layer 21, change to black filament
• at layer 24, change to silver (or gray) filament.

WOLVERINE

• start with yellow filament
• at layer 16, change to white filament
• at layer 21, change to black filament
• at layer 24, change to silver (or gray) filament.

Each .stl file includes a small square tower to help the filament changes.

Happy printing! :)