Bigtreetech SFS 2.0 Filament Sensor Voron 0.2 back mount

I wanted to add the SFS 2.0 to my Voron 0.2R1 and make it as easy as possible. 

Since I use a filament dryer as source for the filament the spool holder was sitting and collecting dust. 

The SFS can be mounted instead of the filament holder with the preloaded nuts in the frame.

I printed it with PETG since it is located outside the printing chamber, and shouldn't be exposed to too much heat.

BOM:

3X M3X6 BHSC (use the ones included with the SFS 2.0)
2X M3X12/M3X16 BHSC (for mounting the on the frame, I used the M3X16 variant, but the M3X12 should be enough)

Print settings:

Material: PETG/PLA+/ABS
Layer Height: 0.2mm
Walls: 5
Infill: Grid, 35%