2"/D50 pipe fitting for probe/sensor/injector holding onto pipe. It has been made with two typical pipe-threads - G1/2 and G3/4. You can look into my other models, where you can find temperature probe sensor shaft for this fitting or special fitings made for various pH/ORP probes.
Printing:
- material for both parts: PET/ASA/ABS
- both parts should be printed in vertical position
- support: Tree, touched build-plate with intra brim (5-8) and top-interface on (0.2mm)
- bridging: on, optionaly if you dont use support for threads/holes (recommended!)
- subsequently restore the thread shape with an appropriate tap after printing
Other material used:
- two hex (13mm) bolts M8x45 with nuts
- o-ring sealing 35x3.2
Tags
The author marked this model as their own original creation.