Adventure 5m (AD5M) Rear Lid Stand

Custom lid stand for the Flashforge Adventure 5m that is made to integrate with the printed enclosure (without the filament spool holder on the back). 

Didn't like most of the solutions I was seeing for lid stands and decided to make this one. It will require:

• 2 12mm M3 Screw (For the bottom of the mount)
• 2 8mm M3 Screw (For the connection between the mount and the stand)
• 1 12mm M4 Screw (For the top of the mount)
• Removal of the metal spool holder on the back
• A modified spool holder plate (@sullivanmusg_1855894 has already uploaded one)

When it comes to printing these. The stand portion I printed vertically with supports. The mount I printed laying down and had some annoying supports to deal with, but should be able to be printed better upright with no supports if you are brave or have a glass bed.

May work on an alternate version to better capture the panel on the side, because it is possible for the panel to fall out due to vibrations during a longer print. I don't usually print with the lid off but this could be a problem for some people.