Finger Fidget

I've had a fidget with gears on it for a while, but I wanted to add a magnet slider so I designed this in a comfortable form factor for me. 

Printing instructions:

Print it however you want. The only thing to be concerned about is that Side 1 has preinstalled supports, but they aren't attached. So when you load Side 1, group it together first.  Then push them out from the hole on the inside of Side 1.

 

Parts Required:

qty 3 - M2x10 cap screws

https://share.temu.com/IA0WYfnBeWA

qty 3 - M2xH4 threaded insert

https://share.temu.com/x3IoTAPnyXA

qty 12 - 2mm x 6mm round magnets

 https://share.temu.com/ayjQr3oBt0A