Xbox 360 Slim 2.5" HDD/SSD adapter

Adapter that will let you use any 2.5" HDD or SSD in a modded Xbox 360 Slim (aka Xbox 360 S). Just slide the drive in, and then plug into your 360. Be sure to pay attention to the orientation of the plug. Includes holes on the back so you can pull this out of the 360 with pliers, and some thumb cutouts up top for easier drive removal.

Print Settings

Printer:

Markforged X7

Rafts: 

No

Supports:

No

Resolution: 

100um

Infill:

37%

Filament: Markforged Onyx Black 
 

Notes: 

Should print fine at 200um layers in PLA, but you may need a smaller layer height for materials like ABS/Nylon for the hexagons to come out nicely. No supports needed. Prints vertically, may need a small brim if you bed adhesion isn't great.

How I Designed This

Designed in Autodesk Fusion 360 using measurements from the original Microsoft branded HDD that came in my 360.