Joycon Grip

Joycon Grip as close as possible to the original while being easily printable

Available in two versions:

• standard, without any modification (with leds NOT visible)
• modified, with holes for the led indicators

Print instructions:

The files should be easy to print as is.

Minimal support is required (only on the build-plate), which is really only necessary for the handles to stand up given the small contact area, and to support the bridge between the handles and the body.

Use a decent brim, say 10mm just to be sure.

I used the default setting "0.30mm DRAFT" from Prusa Slicer latest version (2.8.0 as I'm writing this) and it printed just fine. Make sure that the slicer detects and prints the small walls that catch the joycon, as they are somewhat small walls.

Contribute & remix:

This files are licensed under GPL 3, that is you're basically free to do whatever you want with it, as long as you give proper attribution and use the same license.

The FreeCAD files for both models are available il the Files section