Eight Sleep Pod 4 Cover to 1/2" (Internal Diameter) Hose Adapter

I recently returned a new Eight Sleep Pod, and they didn't want the cover back(?!?), so this model may help breathe some new life into some otherwise e-waste.

I printed it out of PETG at 0.2mm layer height (it was whatever I had lying around).

This model has not been tested with a pump yet!  Even if the tolerances are good, it will likely leak!   I'll come back and update this after testing if I remember 😅

Adds a notch to the cover connector half (so it snaps into the connector) and hose fittings to the other side.