Boeing EA-18G Growler

My Cura settings (settings with * are ones I've found to have a large effect on the quality of the print)

Hatchbox Light Grey PLA

*Temperature: 200 C

Build plate temperature: 60 C

*Layer height: 0.09 mm

Line width: 0.4 mm

*Support line width: 0.3 mm (thinner support line width makes support easier to remove)

*Support interface line width: 0.3 mm

Walls count: 4

*Z seam alignment: sharpest corner

*Seam corner preference: smart hiding

Top/Bottom layers: 6

Infill: 10%

Speed: 45 mm/s

Retraction: 0.4 mm

Combing: not in skin

Support density: 8%

*Support Z distance: 0.18 mm

*Support interface density: 80%

Adhesion: Raft