Anet A6 3-in-one filament guide, USB & SD card holder

I noticed that the filament guide I was using was bending the filament when i was doing higher prints so i thought I would make a new one.

I also decided that I wanted the filament guide to be in the center of the bed and align with the extruder input hole if it was center on the bed.

Then I decided that while I am busy with it I could make it a 3-in-1 tool and add a USB holder and SD card holder on the sides as I use 3 different SD cards at a time.

This design was not created to win awards for artistic looks but rather for practical functionality and simplicity.

I might later tweak the design to be able to hold a spool also.

Print Settings

Printer:

Anet A6

Rafts:

No

Supports:

Yes

Resolution:

High

Infill:

25%

Notes:

I used Craftware to slice.

The Temp settings are:
Heat bed 47 degrees
Nozzle 200 degrees

Total Printing time for all three parts were about 6 hours.

How I Designed This

Software Used

Autodesk 123D Design to create model.
Craftware to slice for printing.

Category: 3D Printer Accessories