Pusi Negotiator for Trinity Origin Decanter 155 Filter Module

This is a remix from my design of the Pusi Negotiator, but redesigned to fit the Trinity Origin Decanter 155 Filter Module. Thanks to EAF member @longpvo for the measurements, photos and providing feedback on the print.

Note on nomenclature: Pusi (푸시) is the Korean word for PUSH. Thanks to EAF member @heytchap for the name.

Updates: 20 Jan 2025 - dimensions updated to fit better.

Printing tips:

• There are some chamfers so its best to use low layer height 0.16mm or lower for visuals, but go nuts with layer height if you don't care about looks. 
• Recommend PETG if you use hot water to rinse filters, otherwise PLA/PLA+ is fine.
• Extra walls and higher infill recommended (but not needed) to give a more solid feel to the shaft / handle.
• You may also want to print with ironing on top layer for a nicer finish.
• No supports needed, just print flat on the bottom.