Voron Exhaust CAN Cable Route

I'm not a big fan of drag chains so I used CAN toolhead board to get rid of X and Y chains. As the first step to eliminate Z-chain I'm rerouting the CAN cable to exit through the exhaust grill and enters the electronics bay through the rear center skirt. This will keep the wiring inside the chamber as clean as possible. The second step will be something I call Z-snake which I'll upload soon. With that, I finally got rid of all drag chains on my printer.

Note: This is designed for 250mm Voron 2.4 with Monolith Panels (6mm gap between rear panel and frame). Feel free to modify the STEP file included to suit your printers.

BOM

• 2 x ECAS04 Collet clips
• 2 x M3x8 SHCS
• 4 x M3x12 SHCS
• 2 x M3x16 SHCS
• 2 x M5x10 BHCS
• 6 x M3 Heat set inserts
• 2 x M3 Drop in T-nut
• 2 x M5 Drop in T-nut

Print settings - VORON STANDARD (No support needed except for the covers)

Repurpose of exhaust grill as an exit for CAN cable and rear center skirt to have channel for cable entrance