Horned Skull Lamp | Demon Skull | Skull with Horns

Hey makers.

Today i bring you this model that i intend to use as a lamp, it's Hollow and you put a 5v LED lamp (or whatever you might have laying around) inside it.

The original model had a lot of polygons and i simplified it a bit but it still has a lot, so it will take a while to slice, i also made sure to have the horns sit at a nice angle for printing but it might need extra supports depending on your machine and settings.

Definitely use White or a light colored material with not too much infill so that light can pass through.

There's two versions of the model, one has a hole in the back for cables and stuff.

FDM machines should use supports for the eyes.

Good luck!

Changed Geometry to optimize model, hollowed it out and cut it to make it printable and flat on the bottom.