AstroCat - HueForge Painting

• No AMS / MMU required!

My first attempt at generating my own image, running it through HueForge, and printing it!

Large model, normal for slicing to take a while.

Instructions :

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
Tested at 100% scale. Z scale must remain 100%.

Filaments Used:
RAPID PLA+ Elegoo Black Transmission Distance: 0.8
RAPID PLA+ Elegoo Blue Transmission Distance: 4.8
RAPID PLA+ Elegoo Orange Transmission Distance: 5
RAPID PLA+ Elegoo White Transmission Distance: 9.6
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Blue
At layer #15 (1.28mm) swap to Orange
At layer #21 (1.76mm) swap to White for the rest.
 
I recommend using progressively lighter colors, as I did, going from black, to blue, to orange, finally to white.