1st Gen Toyota 4Runner Deck Light Housing

This is a housing to allow the factory "deck light" in a 1st gen Toyota 4Runner to be surface mounted instead of inset into the plastic bed side panel. This allows it to be moved from behind the roll bar and moved up higher for better functionality. This was mainly done to facilitate making plywood bed side panels to replace the ~40 year old brittle plastic side panels. The factory cutout would be hard to do in plywood and the cutout also prevents placing the deck light in front of bed side sheet metal up higher.

Photos: 1: The deck light housing and deck light separated

1. The deck light installed into the housing
2. The factory deck light cutout in the plastic panel

I did add a pair of wires, soldered to the deck light bulb, that run out the back of the housing and up to an overhead LED light in the back of the 4Runner. This is optional. I've also rewired the deck light so that it can operate with the vehicle lights off and instead work off ACC power or direct battery power.

And if the lens on your old Deck Light is shot, here's a replacement:

• https://www.thingiverse.com/thing:6699984 Print Settings

Printer Brand:

Type A Machines

Printer:

Type A Machines 2015 Series 1

**Rafts:**

No

Supports:

No

**Resolution:**

0.6mm nozzle, 0.3mm layer height

Infill:

25%

**Filament:** Zyltech ABS or other high temperature material anyCustom Section ==============

Category: Automotive