Towbar step

Every time I put the kayak on the roof of the car and step on the towbar, it gets a little bit tricky. But now with this step it will be easy. And I can sit on it if needed.

Printing

All parts are printable without supports and recommended material is PETG, ASA or PC with 4 perimeters and 30% or higher density of infill.

Pre-assembly

Screw two screws of size M8 with internal hew head and length 20 mm into the LOCK part

Assembly

1st step

You need a European style hitch with a 50mm ball.

2nd step

You put on the tightening nut. Pay attention to its orientation, the nut belongs with the narrower side up.

3rd step

Place the main part on the ball.

4th step

Insert the LOCK part into the BODY section from the top.

5th step

Turn the LOCK part downwards so that the two parts of the thread are next to each other.

6th step

Tighten the nut.