Garmin GLO 2 holder with GoPro adapter

Holder and sun shield for Garmin GLO 2. Includes adapter for GoPro mount. It can be connected to a suitable suction cup holder or any other GoPro holder. I made it for Regularity rally racing.

Garmin clips into place from top and bottom. Friction holder on left is to prevent rattling. Don't brake the clips while removing device from the holder! Put the holder face down and bend clips just enough for Garmin to fall off while tapping it to your lap.

Assembly

Connect adapter with 3×16 mm multi-purpose screws. M3 screws can also be used, but then adapter holes must be threaded with a tap (most preferably with a bottoming tap). Adapter can be mounted in 45° steps.

Printing

• 0,4 mm nozzle
• 0,2 mm layer height
• At least 3 wall loops (because of the screws)
• At least 3 top and bottom layers
• I used 20 % triangle infill

PLA will bend in sunlight, so you may prefer to use something more heat resistant material if used on a car windshield.