Groove Life Belt Hanger w/Magnets

There are basically 2 different configurations… 

#1   Using the ‘buckle’ attachment (Groove_Belt_Hanger2 v15) by itself to hang the belt full-length.

#2   Using both the ‘buckle’ (Groove_Belt_Hanger2 v15)  AND  ‘tail’ (Groove_Belt_Hanger_Part-2 v5) attachments together so the belt hangs half-length.

Hardware:

   8x2mm Neodymium/Rare Earth Magnets (3 for buckle hanger, 2 for tail hanger).

Suggested Print Settings:

   Perimeters:  4

   Fill Density:  20%

   Fill Pattern:  Rectilinear

   Filament:  PLA

   Rafts:  No

   Supports:  No

  Note: Be sure to place the tail end attachment face up on the bed when printing (see photo). I                 was able to get clean magnet holes (hanging side) without added supports.

IMPORTANT:  As sledutah stated, be sure you put the magnets in the holes in the correct orientation or else it won't work.

If you've received value from my work and wish to show some appreciation then please use the link below. Thanks

Buy me a coffee

Great idea, and model. The only reason I remixed is because I have 2 levels in my closet (double hanging rods), so there's only half the height for the belts to hang. To that end I decided to add a rear attachment for the non-buckle (tail end)… so my belts are half as tall when hanging. Also added larger magnets, the 6x2s just didn't give me enough grip… and I added the Groove Life logo (just for kicks).

Kudos to sledutah & NatG763 for the original designs.