Plug for Starbucks Trenta cups

No support plug for Trenta Starbucks cups
2
10
0
60
updated July 28, 2024

Description

PDF

My wife likes her starbucks refreshers. They don't make plugs for the Trenta size, and they are so sticky when they spill in the car. I designed this for her and she loves it. 

I printed them from TPU with a .8mm nozzle at 20mm/s on my Neptune 4 Pro, 2 walls, 50% infill, layer height .2mm, but I'm sure they'd work with smaller nozzles and out of PLA or anything else. They took about 8 minutes to print

There's a small lanyard hole so they can be attached to a keychain or just a loop to hang on your turn signal lever so you don't lose them.

 

v5 is made to print vertically. V7 can be printed laying down. Neither need support as I printed them. YMMV

Tags



Model origin

The author marked this model as their own original creation.

License