Beading loom for small beads (Miyuki Delica 110)

I loved https://www.printables.com/@GerryPB her loom design, but the spacing of the ‘comb’ was too large for my wife's Miyuki Delica 110 bead bracelets.
So I designed my own stand and you need to use the peg and key of GerryPB's design.
You can download those from her design: https://www.printables.com/model/15769-beading-loom/files 
My design has a 1,5mm spacing and 50 slots, so it can be very versatile.

Added a 2mm spaced version with 40 slots upon request 

Printing instructions:
1. Watch the orientation of the holes: pointy bit of the drop shaped hole up.
2. No supports (all 45 degree angles)
3. 0.2 layer height (the design is based on that layer height)
4. Use a 0.4 nozzle (design is based on a 0.42 line width)
3. 10 to 15% infill (doesn't need much for stability
4. 3 walls, 5 bottom and top layers to prevent warping.
5. PLA  works just fine

Enjoy!

 

I wanted a simpeler and faster loom to print for smaller beads.
I didn't use any of the original design.
Though it uses the bead_loom_short_slit.stl and bead_loom_key.stl for the peg to tie on to.