Ferris ISX 800 Light Bar Side Mount

I added this light bar kit to my Ferris ISX 800 Zero Turn.  The main front LED bar was mounted stock but the side lights needed a custom bracket.  

Each bracket is made of two halves, and there is a right set of models and a left set of models.  Each bracket will need 1x M4x25 screw, and 2x M4x16 screws, along with 5x M4 washers and 3x M4 nuts for each.  One nut gets dropped in the shaft slot, to which the 25mm M4 screw is screwed into to connect the shafts on each side.  The remaining two screws are used on the front of the mount as shown in the pictures.

I drilled a hole in the bracket for the included light mount to attach.

I have these lights aimed slightly to the side so I can see on my sides in the event I want to turn.  The front light bar takes care of the area in front.

You'll need:
2x M4x25
4x M4x16
M4 Washer and Nuts

Note: I also created a bracket to adapt the rectangle hole in the side console to accept the round switch included in the kit.
https://www.printables.com/model/952799-ferris-isx-800-zero-turn-light-bar-kit-button-adap