Arzopa S1 Portable Monitor Vesa Mount - Lite

Remix of the mentioned model, but uses 50% of the filament and prints in a third of the time!

Printed in PETG at .28mm layer heights with 2 wall loops and 20% gyroid infill. Print on the edge to have the best strength, I recommend to use a brim as my print actually detached from the build plate but only with a few layers to go so I still used it lol. 

While this uses less filament, it is still really stiff, holds the monitor with basically no flex and holds the monitor really nicely!

Use M4x10 bolts and nuts. I didn't have any M4 bolts and nuts, but M3 worked fine on my mount. Will replace those with M4 when I get the chance. 

Uses 50% of the filament and prints in a third of the time! Makes some cutouts and makes the mount overall less wide.