ZimaCube Side panel with fans

Replacment side panel for ZimaCube with fans.

Fits 2x 40mm fans to exhaust the top CPU compartment.

Fits 1x 90x15mm fan to force air into the drive compartment, directing air onto the NVMe drive sled.

Note: to install you need to first place the panel on the side, slotting it into the two slots that secure the central part of the panel.  Then screw on the 2 40mm fans.

I have printed and fit successfully in PLA and ASA.  PLA is most likely just fine,  but the final version that I installed on the ZimaCube was done in ASA just as a precaution against heat related warping over time.