Pin Pliers

The Pin Pliers can be used to pull out a difficult to remove LEGO Technic Pin.

It prints in three parts and then the small clip holds the two halves of the pliers together.

See the full guide for assembly and use instructions: Pin Pliers

We modified Anachronist's Over-engineered JST connector pliers by changing the front part to be compatible with the LEGO Technic Pin.

These files can be printed on a standard FFF (Fused Filament Fabrication) desktop printer without support.

Check out our other 3D Printed Parts as well.

We modified Anachronist's Over-engineered JST connector pliers by changing the front part to be compatible with the LEGO Technic Pin.