Lifting Scoop For HP Otto
A servo powered lifting sccop modification for HP Otto
7
21
0
224
updated July 25, 2024
Description
PDFI used PLA with 20% infil 0.2mm
The lower arm assembly needs supports.
2 copies of the upper arm are required. The end with an 'F' embossed on it pushes into the scoop
If you have line followers, you need to remove the securing screw from the line follower, for the servo to lie flat. The servo will keep the line follower in place.
Model origin
The author remixed this model.
Differences of the remix compared to the original
Lifting Sccop for HP Otto
