Print-In-Place Nail Guide | NailKeeper

This is a simple model that aids in the initial strike of a nail. It also helps with accidentally striking your fingers on that initial blow… You don't need to admit it, we all do it sometimes…

The tool is entirely print in place, and folds up to encapsulate the nail. There are three different slots for different size nails. 3mm, 2mm and 1mm. Although pretty much any nail can fit as the hinge allows for much bigger, or much smaller nails.

There are two handles on the exterior of the tool that also fold out so that it is super easy to actuate and grab new nails. These handles are also print in place, and are recessed into the part for printing.

If the tool is flipped over, and the angled surface is placed flat against the work surface, you can also nail a perfect 45 degree angle.

Print Settings:

Layer Height: 0.2mm

Infill: 15-30% (More is stronger)

Supports: No Supports! Its all Print-in-Place