Original Xbox Slim

Xbox Slim Case – Designed for a 220x220 mm print bed.

• Uses original controller ports (note: only 2 out of the 4 ports)
• Designed to use the original power button.
• Works with the original Xbox power supply.
• Requires only M3 screws (6 mm or longer) and a 40 or 50 mm fan.
• Modular design

Assembly Steps:

1. Print the Case: Start by printing all the necessary parts.
2. Install the Power Button:
   • Take all three parts of the front button and assemble them like a sandwich.
   • Insert them together into the wall that holds the button.
   • Don’t forget to secure the Power Button Holder with screws to keep it in place.
3. Assemble the Base and Walls:
   • Attach the base to the four walls.
   • There’s one screw that needs to be installed from the bottom of the case.
   • You may need a mallet or hammer to gently fit the walls into place—be gentle with the taps!
4. Install the Motherboard and PSU:
   • Place the motherboard and power supply unit inside.
   • Secure them using the original screws.
5. Install the Controller Board: The controller board can only be placed after the motherboard is installed.
6. Add Storage: Install your HDD or SSD and screw it to the top of the case.
7. Attach the Lid: Secure the lid to complete the assembly.
8. ???
9. Profit

Notes:

• Use M3 screws (6 mm or longer) for the bottom of the case, the front power button PCB, and the lid.
• Fan Shroud: A fan shroud is included but hasn’t undergone proper testing.
• A fully editable STEP file is included for your convenience. Feel free to make any adjustments as needed!

Originally created by ShinGoutetsu and remixed by PlasticBurner, this version has now been remixed by me!

It has been redesigned to be modular while retaining a similar exterior appearance! Original model and remix mostly used as a reference.