VESA 100x100 Rod mount

I wanted to mount my display vertically, but there wasn't a stand included. I did still have a table leg from a local DIY store with a diameter of 30 mm, so I mounted that to my desk and printed this adapter to mount it.

Warning: the display rests on the side, so the adapter itself doesn't carry a lot of weight. Take this into consideration if you decide to mount your display in the air.

Printing instructions

Printed with PLA at 0.30mm layer height, since it isn't visible and was just a quick print. If you mount the display mid-air, make sure to print it in PETG, because PLA probably isn't durable enough. Infill at 25%. Took 3h10m to print.