Keyboard wrist rest - 33cm - For Keychron Q2 /Q2 Pro / Q2 Max and many more!

A 3D printer-friendly keyboard wrist rest. It is both portable and rigid. 

it is precisely 327mm wide to match many keyboards, such as the  Keychron Q2, Q2 Pro and Q2 max.

Each part can be printed together in a single print, and, whilst not my preference, you can print without supports.

The three parts are the following:

• left part
• right part
• connector (friction fit)

This has been tested (as seen in images) and is quite secure and rigid.

Adding feet (rubber, foam, felt etc) is highly recommended. You will need 6 - one in each corner, 2 in the middle (inside of each half)