nothing fancy but make a huge difference. just place them under the bed in the holes and tighten as needed.
be careful. the mount points are plastic and may brake. ( aka i broke one in testing :( )
if you can use TPU
unscrew the 6 screws. Lift the bed up. There are 6 holes. Put the spacers in the holes. Place the bed back on top of the spacers. Tighten the to center screws. Place build plate back on bed. Run QGL and mesh calibration. Tighten the 4 corners as needed. Re run QGL and mesh calibration. Adjust z offset if needed.
The author marked this model as their own original creation.