Voron V02. Skirts - Hexagonal Theme

These modified skirts are based on the original V0.2 skirts. You can simply replace them using the same screws, without any additional steps.

I changed the filament color at 0.6mm and then at 3.72mm layer height. You can adjust these values to vary the thickness of the exposed colored part.

The slot for the screw heads has been enhanced with a fillet for proper installation.

Recommended printing parameters :

• 0.2mm layer height (0.12mm for a smoother ramp look on the hexagon surface)
• ABS or ASA (PLA should work as well since it is not directly exposed to the chamber heat)
• 20% infill
• 3 perimeters
• At least 4 top and bottom layers

Remake of the original skirts for the V0.2 (see the CAD model on the VoronDesign GitHub page).

I added "reverse chamfers" inside each hexagon and provided enough space around the screw head for proper fitting.