Nozzle Cam MK4 from 3DO.eu

First you need this set:

https://3do.eu/3do-camera/2333-3do-enclosure-nozzle-camera-v2-kit.html

You buy:

• nozzle cam V2 DSP PCB 
• nozzle cam V2 FPC Cable (10 to 25cm) 
• 3DO High Temperature USB Cable for Nozzle Camera (USB A to 5P) FEP+Silicone

You print the cam holder as replacement of the X-carriage lower part

You print the PCB board mount an put in a M2 heat sink thread and install that on the upper right corner of the love board and fix it with a little M2 screw.

on that you install the cam DSP PCB with M2 mother board stand offs. and mount a 1cm x 1cm aluminum heatsink on top of the DSP.  

The USB Cable can be placed the same way as the love board cable is. that you connect with a raspberry pi with mainsail and crownsnest installed on it.

That's it :-) 

PCB board mount from @LarryD:

https://www.printables.com/de/model/783324-3do-nozzle-cam-for-mk4-remix

(do that with PETG)

Nozzla cam mount from @Thorsten Lachmann:

https://www.printables.com/de/model/893192-mk4-nozzle-camera-mount-remix-heatbedconnector_col

(print that with PA6-CF, due to heat resistance)

Fan duct also from @Thorsten:

https://www.printables.com/de/model/898028-remixed-improved-mk4-fan-duct-for-nozzle-cam-combi

(print that with PA6-CF, due to heat resistance)

The love board cover is made myself :-) that can be done again with PETG