Arizona Block "A" decoration - University of Arizona

This is the Block "A" of the University of Arizona. It is created in three pieces printed in three different colored PLA.

Print the three parts then glue them together to create the final design.

I also created a different "white" piece that has a stick attached. For that one I printed it at 50% size EXCEPT I bumped the Z to 2mm so that it would be thick enough to come off the build plate and glue together nicely. This was used as a cake decoration.

Both 100% and 50% are shown in the photo.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

No

Supports:

No

0.4mm nozzle, 0.2mm layers

Infill:

40% as this is small

Notes:

I used CA glue (super glue) to put the layers together.rnrnThe part names designate the color you should use to print them (red, white, blue).rnrnThe smaller version was printed at 50% X and Y but bumped to 2mm on the Z so it was thick enough to create the depth and get off the build plate without breaking.rnrnBear Down, Cats!rn