HueForge Stained Glass Butterfly 3

The is the third Hueforge Lithophane Blending Type butterfly in a series, like all of my stained-glass models, it is in TWO parts.  The original art provided in a request from someone has a wide spectrum of colors.  This includes both greens and purples.  Creating green in the final product is not hard, but purple proved to be too hard for me.  I concluded that because Part 2 looks best with red AND yellow.  The yellow is also needed to create the green when parts are joined. The resulting reds are too orange, giving a muddy brown, not purple, when Part 2 is mated to be seen through the blue of Part 1.  Thus, revealing a limitation of this approach.

The first part has just the blues (and greens) and black of the foreground. The second part blanks out the blues (but not the greens) and provides the reds and yellows for the background.  Both parts have very thin base layers, so special care is needed to remove them from the print bed. It is probably best to cool them completely before trying.

When joining the two parts be sparing with the adhesive, especially in the lighter parts. The adhesive will change the colors if it is not behind the darkest parts. I just used some around the darker parts and around the edges to keep the glue from showing. If spread thin and uniformly, it should not show too much.

Part 1

Project: Butterfly3_Part_1_v2.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x149.18mm in size
You may print at higher layer heights below the Min Depth of 0.16mm
The Max Depth is 1.2mm and the Actual Depth is 0.72mm

Filaments Used:
PLA PolyLite Natural Transmission Distance: > 20
PLA HueForge Navy Blue 2.2 Transmission Distance: 4
PLA Overture Blue Transmission Distance: 4.2
PLA PolyLite Black Transmission Distance: 0.3
This print uses 4 unique filaments

Swap Instructions:
Start with Natural
At layer #2 (0.24mm) swap to Navy Blue 2.2
At layer #3 (0.32mm) swap to Blue
At layer #7 (0.64mm) swap to Black for the rest.

Part 2

Project: Butterfly3_Part_2_v5.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x149.18mm in size
You may print at higher layer heights below the Min Depth of 0.16mm
The Max Depth is 1.2mm and the Actual Depth is 0.8mm

Filaments Used:
PLA PolyLite Natural Transmission Distance: > 21
PLA PolyLite Lemon Yellow Transmission Distance: 6.5
PLA Overture Red Transmission Distance: 4.8
PLA PolyTerra Army Red Transmission Distance: 0.3
This print uses 4 unique filaments

Swap Instructions:
Start with Natural
At layer #2 (0.24mm) swap to Lemon Yellow
At layer #4 (0.4mm) swap to Red
At layer #6 (0.56mm) swap to Army Red for the rest.

If substituting filaments, pick ones with the closest TD values. Use a Natural white, if possible. Otherwise, pick the one with a TD > 10 to minimize the color change it will cause.