Intex sand pump O-ring/L-ring

This replacement part is for Intex part number 11412.

L-shaped O-ring seal for sand pump or any other 1.5'' inch threaded connection.

Print with TPU. No support is needed. Use a smooth print plate for better water tightness with another object that will go on top of it. Print takes 20m with BambooLab Carbon X1. The softer TPU, the better. I used 90A, but softer would work even better. 

I designed this so I can use it with my pool fountain    https://www.printables.com/model/943903-pool-fountainwaterfall