Certain slim/key sized USB flash drives are prone to the metal casing bending and "bowing" in. I created this end-cap in an effort to reduce the chances of my Kingston DataTraveler SE9 Gen2 drive caving in.
There are two versions:
SHORT - outer wall is 7 mm tall, inner tongue is 10 mm
LONG - outer wall is 12 mm tall, inner tongue is still 10 mm
Printer Brand:
FlashForge
Printer:
FlashForge Creator Pro
Rafts:No
Supports:
No
Resolution:0.1
Infill:
75%
Notes:
Due to the tight tolerances and small gap between the outer walls and the inner "tongue", consider printing at 0.1 layer height.
Category: ComputerThe author marked this model as their own original creation. Imported from Thingiverse.