break lever mount for dropbar

This break mount is designed to adpat a “mountain bike”-style break (in this case a magura mt) onto a “road bike”-style dropbar. A cheap alternative to the quit  expensive “road bike”-style break levers.

Depending on how much you can stretch the part, it will fit a range of diameters. It is held in place by the tension of screws on the break lever.

There are two slots for screw nuts on top, in caser u want to mount a small handhold on top of the breks.

CAUTION. As the break plays a crucial part in the bikes safety, make sure to print this part strong enough. Also use resistant material, like ASA, to make sure it will stay strong even when exposed to sunlight or rain.

Make sure to print the part oriented as shown in the picture, so it  wont break inbetween the layer lines.