IKEA LACK Enclosure Corner Parts

With these parts you can build your own IKEA LACK enclosure for your printer.

The files you find in this model are devided in top an bottom parts. Every part of the corners is designed to hold a glass pane with 5 mm width.

Print files

The top parts are identical for the rear side of the enclosure. The front is devided in right and left part.

The bottom parts are devided in different versions. There is one pair cones and morses with a hole in it. This is used to lead the cables of the printer out of the enclosure. If you want to place your PSU outside the enclosure you should use this model. The remaining three cones are identical. The three morses differ by the position of the glass holders.

Before printing please read the notes on every model. You will find the needed amount there.

Additional Parts

You will need screws to mount the corner parts to the table tops. To attacht the glass panes you will need nothing further as the glass is simple stuffed into the corner parts.