4010 Fan adapter for the Manta MK2 with BL Touch

4010 (40x40x10 mm, 9 blades) Fan adapter for the Manta MK2. They didn't seem to have any for the stock Ender 3 Pro that I have. So made an adapter with the BL Touch. You'll still need to add the M3 thread inserts for the fan and you'll need four M3 x 16mm screws for it. You'll also need to use two M3 x 16mm screws for the left arm where the BL Touch will be installed.

To install, just simply attach the bottom lip to the bottom of the fan shroud. Then, attach a support arm to keep it in place. It's that simple!

Print the adapter as you see fit, just make sure that the bottom lip stays put and doesn't break. It's what's keeping it close for the most part.

I printed this using PETG, as the main creator of the fan duct has with the rest of it. So, no need to exchange filament.

NOTE: I'm still new with 3D printing at this point and haven't been able to mess with the G-code as the original creator has it. So far regular BL Touch installation and update have been plentiful.