Master spool (refill) from eono spool

This is a kit to convert a 'eono' filament spool to a refillable spool.

You'll need to cut the empty spool in 2 halves (following the existing joint) then you can use the bolt and center ring to reassemble it.

2 rings allow to increase the inner diameter of the spool to match 'esun refilament'.

No support needed.

Prints ok at 0.35mm layer with a 0.6mm nozzle

Print Settings

Printer Brand:

Prusa

Printer:

No

Supports:

200

Infill: