Magnetic shower drain hair catcher

I made this magnetic hair catcher cover for my shower drain as there was nothing out there that wasn't disposable or just didn't work with my drain. My shower drain is a 2 inch with a nickel plate steel cover. 

I made 2 versions; one with embedded that will need to be inserted into the print and the other has exposed magnets if you dont feel like dealing with adding stop gcode and what not. 

I used 20% gyroid infill on cura to get the mesh that you see in the pictures. I removed top and bottom walls; left the side walls so that the hair gets caught on the top only and not the sides. Printed in PLA and used 5mm magnets from amazon 

If you use the embedded magnet version you will need to add the “stop at height/layer” gcode on cura. You will also need to do the following:

Add both files “drain v2 embedded magnets 1” and “drain v2 embedded magnets 2” and you'll have to center both. “drain v2 embedded magnets 1” will need to have it's own settings. I will add pictures of the steps.