KYZ HSW Ball Holders - 6 Sizes

Introduction

Pretty self explanatory, put your balls here!

The size refers to the ideal diameter of the ball you are storing. Measure your ball and round up to the nearest size.

Designed to fit onto HSW (Honeycomb Storage Wall) boards. The display stand, if you were wondering, is here and a smaller one is here.

The Pokeballs pictured are by creator N3D on Makerworld and are printable with a single colour printer one colour at a time, and you can find this particular one here. They have a nominal diameter of 70mm.

Material

• Suggest PLA, ASA, ABS, PETG-CF or similar stiffness materials.
• If you use PETG, the clip will be a little too easy to remove and
• If you use a stiff material like ASA-CF or ABS-GF, the clip will be difficult to insert/remove.

Print settings

• 2+ perimeters
• I suggest slowing down the outer walls to ensure the part comes out strong with consistent gloss level all around (but this is optional).
• This is a fairly easy print, everything else is up to you!

General precautions apply - ensure your build plate is clean (wash with hot water and dish soap and dry with a clean towel), add mouse-ears and/or apply some glue if you often have adhesion issues.

Support

If you would like to say thanks, please post a make and share here and on socials. You could buy me a few metres of plastic on Ko-Fi otherwise, please post a make and check out my other HSW models in this collection. If you are using these stands as a part of your business and are finding it helpful, please consider buying this price label model to support more projects like this.

Remixes with significant changes are very welcome.