Nerf Raider / Rampage grip for picatinny and Dart Zone rails

A grip I modeled after the Nerf Raider/Rampage that attaches to picatinny rail. It's not an exact 100% one to one of the grip but it's as close as I can get, and it feels the same in the hand. It's my favorite pump grip Nerf has made, and I really wanted a version I can use on todays modern springers. 

Hardware: It uses TWO (2): M5 x 35mm socket head bolts, and TWO (2): M5 nuts. There are 5 total screw holes to allow for positioning on sometimes small picatinny rail pump segments. The model simply slides onto the rail and the bolts lock it on and squeeze the grip to the rail. 

Print settings: Support enabled but may need to be blocked from generating on the grip “trigger” area as support is only needed on the bottom and screw holes. I would recommend at least 3 walls and 30% infill for light prime springers like a stock Nexus. At higher spring loads 4 walls 50% infill or stronger will be needed.  

EDIT: The original picatinny attaching grip struggled to properly attach to the rail on Dart Zone pump segments, so I made a version that will specifically attach to Dart Zone blasters. The two grips are also labeled on the inside of the rail attachment, either: PIC for picatinny or DZ for Dart Zone.