GPU Kit Card

GPU Kit Card

Inland Filament Used: 

• Dual Color Silk Gold-Grey
• Black PLA+
• Silver PLA+

Printer Settings:

• 1 Hr 11 Min
• 220°C Nozzle Temp
• 60°C Bed Temp
• No Supports
• Infill: 15% Gyroid
• Speed: 100mm/s wall, 180mm/s infill, 300mm/s travel
• Assembly Instructions: 

1. Using a flush cutter remove the GPU parts from the sprue
2. Place the first fan with the chamfered part pointing out
3. Insert the axle with moderate force (depending on your printer's tolerances/ material)
4. Press fit the grated vent into its corresponding cavity (may need a drop of glue if too loose)
5. On the back side place the second fan just as the first one was done 
6. For the bracket, inset the clip into it and then press both into the two holes on the flat square end of the model. This may take force for a solid fitment and depending on the flexibility of your printed material.
    

STL designed by _cosmic_forge