Check out Prusa's Black Friday Deals. Only valid until December 3rd!

ESRack - Module - Ubiquiti UniFi Switch Flex Mini

ESRack module for Ubiquiti UniFi Switch Flex Mini (USW-Flex-Mini)
11
51
0
277
updated September 24, 2024

Description

PDF

Introduction

When I decided to assemble my HomeLab Rack I wanted each device to have its own dedicated holder, as I like to keep everything tidy and wanted to avoid a mass of shelves. Unfortunately I couldn't find any satisfactory solution, so I decided to design my own modular solution that would allow multiple configurations.

The ESRack system includes components:

  • Mounting Brackets - used to install unit in the rack, avilable in 3 sizes:
    • Short
    • Medium
    • Long
  • Device Modules - each module can handle a single device

Possible Configurations:
- [Mounting Bracket Short] + [Module] + [Module] + [Mounting Bracket Short]
- [Mounting Bracket Medium] + [Module] + [Mounting Bracket Medium]
- [Mounting Bracket Short] + [Module] + [Mounting Bracket Long]
- [Mounting Bracket Long] + [Module] + [Mounting Bracket Short]
- [Mounting Bracket Long] + [Mounting Bracket Long] (Blank Front Plate)

All modules were designed with very little clearance so installation of some devices may need to be pushed in by force.
Before you start printing the system, print the Connecting Block to check that you will be able to connect the modules.

I apologise that there are no detailed photos of the components after printing, but before assembly. It's because I decide to publish this project after fully assembling the racks.

All parts of ESRack system can be found here.

If you like my work you can support me and Buy Me A Coffee ;)

Part Description

Module Holder for Ubiquiti UniFi Switch Flex Mini.

Suggested Print Settings

Material: PLA+/PETG (I used eSun PLA+)
Nozzle: 0.4 mm
Layer height: 0.2 mm
Wall loops: 3
Top/Bottom shell layers: 3
Infill: +25%
Infill pattern: Gyroid
Orientation: Print on front surface
Support: Not needed when correct orientation is used

High infill is needed to avoid bending after installing equipment. I used 20% infill and with heavy equipment it's bend a bit.

Assembling

To connect the each individual modules together, you need:
- 4x M4 nuts (DIN934M4)
- 4x M4x12 allen screws (DIN912M4x12-8.8)

Use standard rack screws and nuts for rack mounting.

Changelog

  • 2024-07-15 - Initial release
  • 2024-09-24 - Rename from Rack System to ESRack

Tags



Model origin

The author marked this model as their own original creation.

License