Hanger holder for screwdriver DeWALT DCF680G2

Do you own amazing gyroscopic DeWALT DCF680G2 and has no place for storage? This hanger holder is perfect for hang screwdriver and two batteries in bottom of shelf.

There is hole for screwdriver and small gap to keep device in even in "not perfectly horizontal installation". Second battery can be stored in bottom part.

Another idea is to make holes for screwdriver's bits above battery, but I'm not sure if somebody needed. Just let me know your opinion in comments.

If you print this thing, I will be happy to see your make in "Post a make".
If you find this even useful, you can buy me a Mr. Brown coffee ;-)

PayPal me: paypal.me/elcarloscz
BTC: bc1q6qz298fescrhxzfwknuysek4x0jzyrvy2lnnz0
ETH: 0x0b55c5DA1f22150A6DA3d0E87fB0674041F22446
LTC: ltc1qqvrng2wlc7kzv8f764372tjprt052unykv93dl
XRP: rPZNYxUyLYxsHK5dr3gaDv5uzAN5fgopjg
DOGE: DCz3cB8W9bgocPP2z6mcQbpuoynLmLzToy

Print Settings

Rafts:

No

Supports:

No

Resolution:

0,2 mm

Infill:

30

Filament:
Fillamentum PLA

Notes:

My prototype was printed with 0,6 mm nozzle, layer heigh 0,35 mm and only 15% Gyroid infill. I was suprised that even in this "fast-mode" hanger seems to be good for hobby use.

Anyway, final print was made with 0,6 mm nozzle, 0,2 mm layer height and (just for sure) 3 perimeters. No supports needed.

Post-Printing

There is 2 holes for screws up to 4 mm diameter.

Category: Tool Holders & Boxes