Multiboard - Drawer Container Organizer System (no supports)

Set of Containers that hold drawers to put on your Multiboard. Giant front handle for holding and for labeling. Containers have a nice bump to keep the drawers from falling out. Can be stacked while still allowing for a 7mm gap to get your fingers under the drawer handles. Internal Drawer is sloped so nothing has a chance to get stuck on the front wall of the drawer.

Prints with no supports.

Container - Print with the back of the container as the bottom.

Drawer - Prints normal.

Settings 

.3mm layer height 

4 walls 

20% infill

How to use: You will need at least one multiboard connector for each edge of the bin, but may use as many as you like. Connect those to the multiboard, then just slide the bin over all the connectors. The bin should “click” in when pushed down.

If you want to remove a bin just push it up again. You may then reconnect to any other connectors.

Sizes: The multiboard bins use a X Y Z naming schema where:

• X is the width of the bin
• Y is the depth of the bin
• Z is the height of the bin

All sizes have to be multiplied by the 25mm multiboard grid size. So when the bin is named “3x2x1” it is 75mm wide, has a depth of 50mm and a height of 25mm.

Warning: The multiboard grid is pretty small. This means that 1x1x1 bin just 25mm x 25mm x 25mm. Please ensure you really get a bin that is big enough.

Credits to Jonathan (KeepMaking) for creating multiboard.

Credits to David for creating multiconnect.

Mine is a drawer system instead of a bin.