This holder(mount) magnetically coupled your two ski poles together. Then magnetically hold itself onto your ski jacket so you don't have to plunge your ski poles into the snow whenever you need your hands anymore.
Locking Mechanism
2x M3 x 20 machine screw(Head diameter < 6mm, Head height < 2mm)
2x M3 square nut (Length < 6mm, Thickness < 2mm)
2x M3 hex nut
With the square nut tightened up against the screw head, the square nut+screw head should not be over 4mm or it may not fit.
Main Body Hinge
2x M3 x 30 machine screw(Any M3x30 should work)
2x M3 hex nut
Base Plate
4x M3 x 12 Flat Head machine screw(Also possible with any M3 machine screw as long as it is 12mm in length)
4x M3 square nut
Magnet
12x D10 x 10 cylindrical magnet
Total requirement
4x M3 x 12 Flat Head machine screw
2x M3 x 20 machine screw
2x M3 x 30 machine screw
4x M3 hex nut
6x M3 square nut
12x D10 x 10 cylindrical magnet
My print setting is for reference only.
Material: Polymaker Polylite PLA (PETG could be better)
Print temp: 210°C(First layer), 215°C
Bed Temp: 60°C
Infill: 15% Gyroid
The model has been positioned to be printed without any support. However, I have not tried to print it this way and instead separated the parts and added support to the hinges overhang manually.
The standard versions have support pillars at the corner of where the overhangs are, you will need a cutter or clipper to remove the built-in pillars.
The author marked this model as their own original creation.