Minimal riser for 15mm laptop

Designed for thicker laptops (mine is 15mm). It clamps on, so the laptop doesn't slide out… which is a problem I often had with other models.

Printed in rPLA, .20mm layer height.

2 versions:
A flat version. You can print 4, and raise up the whole laptop during renders etc.
An angled version, marked with L and R, for during work.

Print without support or brim, just flat on the side. I like to give it a concentric top and bottom infill, just for esthetics.

Some extra things to do, maybe… I designed them to be modular, but didn't figure out a good system just yet. For transport: in the slicer you can bool a hole through them for a paracord, keychain or even laptop cable.

I hope you like this :) do let me know any comments you might have!