Big-bait model SWIMER big lure

Overall length: 230mm

Please model the lure vertically.

It is already jointed, so please model it as is.

There is a weight room in the width section. Use M3 nuts and M3 screws.

The dorsal fin and tail fin should be modeled with TPU.

Dorsal fin: Insert it by sliding it in from the back.

Tail fin: Insert it by pushing it in from the back.

It requires a lot of force, so please use pliers or other tools to assist.

This design is intended to prevent the fins from coming loose.

Approximately 35g of weight is needed.

Enjoy using this SWIMER.

Print settings: 

• I printed it with Bambu Lab P1S
• Layer hight: 0,2 mm
• Infill density 20 % (Grid)  
• Wall loops: 3
• Manuel support 
• Material: Esun PLA +